FCC FlexTT5 Transceiver for Nikon

$ 186.00

Use the FlexTT5 Transceiver with the MiniTT1 Transmitter to control single or multiple off-camera electronic or intelligent i-TTL / CLS Speedlights.

You can now place TTL or manual flashes anywhere to illuminate the scene: Around corners, out-of-sight and in bright sunlight. The MiniTT1 and FlexTT5 are compatible with any PocketWizard radio for triggering manual flash or remote cameras.

This is an FCC frequency radio which can only ship to an address within the United States.  For anyone outside the US, please visit our Where to Buy page to find your favorite dealer.

Key Features:

Dedicated TTL Triggering

Manual Power Control


High Speed Sync (Auto FP)

USB Upgradeable

See details at the PocketWizard Wiki.


TTL Compatibility:

Nikon i-TTL


340.00 - 354.00 MHz US FCC / IC


52 Channels over 26 Frequencies (FCC/IC)


2.7" (6.9 cm) rubberized with 180 degree swing

Transmit output power:

Less than 0.001 watt (1/1000 of a watt or 1 milliwatt)

Range Performance:

Up to 10 to 240 meters (30 to 800 feet) for E-TTL II triggering.  Up to 10 to 365 meters (30 to 1200 feet) for basic triggering. Range is dependent on multiple factors including equipment, mode, environment, positioning, orientation and interference.


Hot Shoe, 1/4-20, lanyard, velcro

Maximum Shooting Rate  Frames per second (fps)

TTL Mode:  within 1 FPS of camera's maximum FPS
Basic Trigger Mode: Camera Max FPS
* dependent on flash power settings 
FPS = Frames Per Second

Power / Channel Switch

OFF - C.2 - C.1

Zone Select Switch

A-B-C (matches Nikon zones)

Status Indicator

LED: Green, Amber, Red status indications

Camera / P1 Port

1/8" (3.5 mm) stereo miniphone for 2-stage remote camera triggering.  Port Voltage Handling: up to 50 Volts, 100 milliamp continuous
Tip = Trigger
Ring = Pre-Trigger
Sleeve = Ground

Flash / P2 Port

1/8" (3.5 mm) mono miniphone.  Port Voltage Handling: up to 200 Volts, 4 amps peak, 250 milliamp continuous, non-polarized

Minimum Receive Contact Time

Camera / P1 Port = 80 milliseconds

 Flash / P2 Port = 500us

Voltage Present

3.3 VDC (all pins) - safe for all cameras

Hot Shoe voltage protection:

Hot Shoe: up to 50V


USB Compliant 2.0, Mini-B Connector, 5VDC regulated, 100mA, Pin 1 Positive, Pin 4 Ground

Operating Temperature

Above -15° C (5° F) and below 50° C (120° F).

Storage Temperature (without battery)

Above -30 C (-22 F) and below 85 C (185 F)


High impact plastic, captive battery door
Hot Shoe made of glass reinforced resin


Two (2) AA (IEC:LR6) Alkaline recommended, other chemistries (NiMH, NiCAD, Lithium) allowed, USB

Battery Life

60 + Hours 


3.6" (9.2 cm) long x 2.9" (7.3 cm) wide x 1.4" (3.6 cm) tall, antenna lowered


5.4 oz (153 grams) 3.8 oz (108 grams) without batteries

Included in the box

FlexTT5 Transceiver, USB cable, Two (2) AA batteries, Quick Guide

ROHS Compliant



The MiniTT1 and FlexTT5 for Nikon are compatible with these modern Nikon digital cameras capable of using Nikon's latest i-TTL / CLS protocol:

Currently Supported Cameras
Nikon D5 Nikon D850 Nikon D7500 Nikon D3500*
Nikon D4S Nikon D810 Nikon D7200 Nikon D3400*
Nikon D4 Nikon D800 Nikon D7100 Nikon D3300*
Nikon D3x Nikon D800E Nikon D7000 Nikon D3200*
Nikon D3s Nikon D750 Nikon D3100*
Nikon D3 Nikon D700 Nikon D3000*
Nikon D2x Nikon D610
  Nikon D600 Nikon D5500 Nikon D90 
Nikon Df  Nikon D300s Nikon D5300*  Nikon D80
Nikon D200 Nikon D5200* Nikon D40x*
  Nikon D300 Nikon D5100* Nikon D40*

* These cameras do not support HyperSync or HSS/FP-Sync operation: D5300, D5200, D5100, D5000, D3300, D3200, D3100, D3000, D40x, D40

The MiniTT1 & FlexTT5 for Nikon are compatible with the following modern Nikon Speedlights as Remote flashes and Nikon On-Camera Master flashes: (Other flashes may work in Basic Trigger Mode without CLS / i-TTL.)

Nikon Speedlights as Remotes

  • SB-5000
  • SB-910
  • SB-900
  • SB-800
  • SB-700
  • SB-600
  • SB-500
  • SB-400 (not capable of HSS)

Nikon Speedlights as On-Camera Master Flashes

  • SB-5000
  • SB-910
  • SB-900
  • SB-800
  • SB-700
  • SU-800 Wireless Speedlight Commander

Note: The "GN" ratio mode of the SB-700 is not supported.